FREE SHIPPING TODAY - FAST AND FREE IN THE UNITED STATES30-day returns
IN STOCK - READY TO SHIP!

Inflatable Pumpkin Stack for Halloween Lawn Decor

  • Three stacked pumpkins, lit from within
  • About four feet, suits small yards
  • Packs down to a small box

$109.99 USD $146.99 USD

| /

Accepted payment options

Dimensions & Fit

Around 4 ft (120 cm) tall inflated, ships folded at 7.9 × 7.9 × 3.9 in. Plugs in and inflates in place.

Inflated height Approximately 3.9 to 4 ft (120 cm). A compact stack, waist to chest height on most adults
Design Three stacked pumpkins with carved jack-o'-lantern faces, green collar leaves and a brown stalk
Lighting Internal LEDs light all three tiers from within after dark
Material High-quality polyester cloth
Packed size 7.9 × 7.9 × 3.9 in, 1.8 lb, white box packing
Power Corded blower at the base, plugs straight into a standard household outlet. The blower runs the whole time it is up
You supply An outdoor-rated extension cord. Check the packaging for the stake and tether count supplied
Placement Outdoor lawn, porch or driveway, within reach of an outlet. Also suits an indoor entryway
Installation guide (15 to 30 minutes)

Before you start. Flat ground clear of rocks, sticks and thorns, away from branches and power lines, and out of low spots that puddle. At around four feet it is a compact piece, but a stacked shape is taller than it is wide, so setting it near a wall, hedge or fence to cut the wind load is worth doing.

  1. Unroll it facing the right way. Find the blower at the base, the power port, the tether loops, the base stake sleeves and the deflation zipper first.
  2. Check the blower collar is secure. Close every zipper and tie off any open port. An open port is the single most common reason one of these will not stand up.
  3. Test-inflate before anchoring. Plug in on a clear dry patch and check all three tiers fill and the stack stands straight. It fills in under a minute.
  4. Position it, then stake the base through the sleeves, driving the stakes at a slight inward angle rather than straight down. Angled stakes hold far better against the upward pull of wind.
  5. Run the tethers out to stakes at about 45 degrees, keeping tension on the fabric as you drive each one. On a stacked shape this matters more than on a low one.
  6. Fill any ballast pouch with sand or gravel if one is fitted.
  7. Even it out. Let it fully inflate, walk around it, adjust the tethers until the stack stands vertical, and tug-test every anchor.
  8. Re-check the next day and after a week. Stakes work loose as ground dries.

Order matters: inflate, position, anchor, then tension. Anchoring it flat gives crooked tethers.

Power. Supplied cords on yard inflatables are short, so an outdoor-rated extension cord is effectively required. Use a grounded three-prong outdoor cord, 14 AWG or heavier, into a GFCI outlet. A cord that is too thin or too long starves the blower and the stack sags. Keep the cord and adapter junction off the ground and out of puddles.

On a driveway, patio or deck, where stakes cannot go: sandbags or water bags at every anchor point, or tie off to deck posts, fence rails or railings.

Weather, troubleshooting and storage
It goes flat when I unplug it Working as designed, and the most common misunderstanding with any yard inflatable. The fabric breathes on purpose and the blower replaces that air continuously.
It is up when powered and flat when not. An outdoor timer plug handles it automatically.
The stack leans Uneven tether tension is the usual cause on a stacked shape. Then check for an open zipper or port, a kinked hose, debris in the fan, or an undersized extension cord.
Re-tension evenly all the way round before assuming a fault.
Wind No manufacturer publishes a wind rating for this class. Industry guidance puts the practical limit for a well-anchored yard inflatable at roughly 25 to 30 mph sustained, and a stacked shape reaches it sooner.
Above that, unplug it and let it lie flat.
Rain Light rain with the blower running is fine, and better than leaving it collapsed in the wet.
Take it down for storms and heavy wet snow. Keep the blower and cord junction out of direct water.
Small tears It runs at low pressure, so it needs enough closure for the fan to keep up rather than an airtight seal.
Clear packing tape from the inside, or a few hand stitches.

Storage. Unplug, open the deflation zipper and press the air out from the top down. Bag the stakes separately so they cannot puncture the fabric. Dry it completely before folding — put away damp it comes out mildewed, and those stains do not lift from printed polyester. Fold loosely along the existing creases and store cool, dry and out of direct sun.

One safety note: guy lines across a lawn are a trip hazard for anyone walking up in the dark. Site it so the tethers do not cross the route to the door.

The Inflatable Pumpkin Stack builds three carved jack-o'-lanterns into a single tower, each face grinning out from the tier below it with green collar leaves filling the joins and a curled stalk on top. At around four feet it reads as one front yard centerpiece rather than a scattered set of props, and the vertical form holds attention from the sidewalk without needing a wide run of open lawn to sit on.

Setup runs off a powered blower built into the base. Stake it down where the display goes, plug it in, and all three tiers fill and light from within in under a minute. It draws from a standard household outlet, so no adapter or special wiring is involved. Takedown is the reverse, and the whole thing settles flat once the power is cut.

The shell is high-quality polyester cloth, light enough at 1.8 lb to move between a lawn, a porch or the end of a driveway as the display grows through October. It folds back into its box at 7.9 by 7.9 by 3.9 in, which is small enough to keep on a shelf with the rest of the seasonal decorations rather than surrendering a corner of the garage to it. Stored folded rather than rolled, the polyester comes back out the following year without the hard creasing stiffer inflatable materials tend to hold.

We want you to love your Lunorre purchase! If you're not completely satisfied with your order, just reach out to us within 30 days of delivery, we're always happy to help!

You can contact us anytime at Info@Lunorre.com we're always here for you!

Shipping Information: We process orders within 1-2 business days. After dispatch your order will arrive in 6-9 days!

Free Shipping In The USA

Free Shipping On All Orders

Dedicated Support Team

Questions? We're Here to Help

Easy 30 Day Returns

Quick and Easy Returns, No Hassle

Secure Payments

Encrypted and Safe Checkout

Shop Your Space Today

Timeless Design, Lasting Impression

Every piece at Lunorre is thoughtfully selected to bring warmth, elegance, and timeless design into the home. From the light overhead to the rug underfoot, we curate pieces that don't just fill a room, they transform its atmosphere and elevate the way you live.

View Our Story

Our Promise, In Writing

We want you to love what you ordered. The design, the finish, the way it feels in your home, all of it. And if anything arrives damaged, defective, or isn't what you ordered, we'll make it right with a replacement or full refund, return shipping on us. That's not fine print, it's the whole point.

Shop The Collection
Frequently Asked Questions

Around 3.9 to 4 feet inflated, waist to chest height on most adults. It ships folded at 7.9 by 7.9 by 3.9 inches (20 by 20 by 10 cm) and weighs 1.8 lb (0.8 kg), so it stores easily out of season.

An open zipper or an untied port is the most common reason. Check the blower collar is secure, then look for a kinked air hose, debris in the fan wheel, or an extension cord too long or too thin for the blower.

It has a US plug and runs from a standard household outlet. An outdoor rated extension cord is still needed: grounded three prong, 14 AWG or heavier, into a GFCI outlet.

Nothing, shipping is free on every US order, with no minimum required. It's automatically applied at checkout, so you'll never see a shipping charge added to your order.

Orders placed by 5:00 PM EST start processing the same business day. Handling takes 1–2 business days and transit typically takes 5–7, so plan on your order arriving within 6–9 business days, delivered by USPS, UPS, or FedEx.

The moment your order ships, we email you a tracking number. You can follow its journey anytime on our Track Your Order page, and if anything ever looks off in transit, reach out and we'll chase the carrier for you.

You have 30 days from delivery to return any item, as long as it's unused and in its original packaging with all accessories. We never charge restocking fees. Just email Info@Lunorre.com with your order number to get started.

We'll make it right at zero cost to you, return shipping is fully covered for anything damaged, defective, or incorrect, and we'll send a replacement or full refund. For change-of-mind returns, you cover the return shipping; original shipping charges aren't refundable.

Once your return arrives and passes a quick inspection, your refund is issued to your original payment method within 7 business days. Your bank or card provider may take an additional 3–10 business days for it to appear on your statement.

Email us at Info@Lunorre.com or call +1 8022677628, our customer service team is available Monday to Friday, 9:00 AM to 5:00 PM EST, and we reply to every email within 1–2 business days.